Temporary Sewing Settings
Change your temporary sewing settings when you want to
change a sewing related setting for your current project.
Changes made to temporary sewing settings will be reset at
the start of a new JoyOS ADVISOR™ project from the
JoyOS ADVISOR™ feature. When turning the machine off,
all changes made in temporary sewing settings will be reset to
default.
The following settings can be set in temporary sewing
settings:
• deLuxe™ stitch system
• Presser foot lift
• Automatic thread cutter
• Automatic FIX
• Stitch limiting options
• Feed teeth options
deLuxe™ Stitch System
When the deLuxe™ stitch system is selected your machine
will automatically choose the best way to control the upper
thread, thread portioning or thread tension, based on your
selected stitch and settings. Thread portioning automatically
and continuously measures the fabric thickness to portion
the correct amount of thread for the selected stitch. When
using thread tension, the tension discs will keep the correct
amount of tension on the upper thread.
For best sewing results we strongly recommend you to keep
this setting selected except when using specific special
techniques or accessories that do not support thread
portioning. Deselect the deLuxe™ stitch system in the
temporary sewing settings to switch to thread tension.
The control for adjusting thread portioning/thread tension,
visible in sewing mode, will change depending on the active
stitch and whether the deLuxe™ stitch system is selected or
not in temporary sewing settings.
Sensor Presser Foot Lift
When selected, the machine automatically raises the presser
foot in the following situations:
• When stopping with the needle in the down position the
presser foot will automatically raise to pivot height.
• After a cut the presser foot will be raised to lift position.
When deselected, the presser foot will stay lowered.
154 11 Settings
To Next Page
Loading...
