CHASSIS
940043-002 INTEGRATED ENTERPRISE NETWORK 2-17
IEN 5000
The IEN 5000 chassis has sixteen full-function slots labeled 0 through 15, that are capable
of running each Hypercom port processor. A seventeenth slot, labeled C, is thinner than
slots 0 through 15 and does not access the high-speed bus. The C slot is used by port
processors that do not have modules attached, do not require an RJ11 port, and do not
require access to the high-speed bus.
The IEN 5000 chassis is typically used at host or regional sites where port density and
scalability are important. The IEN 5000 chassis can function as a regional concentrator of
feeder nodes. As a stand-alone unit, it can perform as a powerful multiprotocol router.
The IEN 5000 chassis contains redundant power supplies. Power supplies are available in
110VAC, 220VAC and 48VDC configurations. A single power supply failure results in an
alarm to IENView.
To Next Page
Loading...