Chapter 3. Graphical user interface overview 127
Clicking an existing partnership opens a window, as shown in Figure 3-78. From this window,
you can also set the background copy rate. This rate specifies the bandwidth, in Mbps, that is
used by the background copy process between the clusters (Figure 3-78). In our case, we
configured the partnership only on one side.
You can see it in the State row. It shows Partially Configured: Local, which is an indication
that the configuration was only configured on one side. If you see this message, go to the
second system, and configure the Create Partnership settings there, too.
Figure 3-78 Partnership properties
3.8 Access menu
The Access menu has two options:
Users (for user management)
Audit Log
Figure 3-79 shows these options.
Figure 3-79 Access menu
To Next Page
Loading...
