Chapter 12. RAS, monitoring, and troubleshooting 707
10.Select Edit → Call Home → Test to test the Call Home function, as shown in
Figure 12-70.
Figure 12-70 Test Call Home.
Disabling and enabling notifications
Email notifications can be temporarily or permanently disabled at any time, as shown in
Figure 12-71. Disabling email notifications is a preferred practice when you run maintenance
tasks, such as upgrading code or replacing parts. After the maintenance operation, remember
to re-enable the email notification function.
Figure 12-71 Disabling email notifications
The same results can be achieved by using the CLI and entering the svctask stopmail and
svctask startmail commands.
12.6 Audit log
The audit log is useful when you analyze past configuration events, especially when you try to
determine, for example, how a volume ended up being shared by two hosts, or why the
volume was overwritten. The audit log is included in the support package to aid in problem
determination.
The audit log tracks action commands that are issued through the CLI or the management
GUI. It provides the following entries:
Name of the user who issued the action command
Name of the actionable command
Time stamp of when the actionable command was issued on the configuration node
Parameters that were issued with the actionable command
Failed commands and view commands are not logged in the audit log. Certain service
commands are not logged either. The svcconfig backup, cpdumps, and ping service
commands are not logged.
To Next Page
Loading...
Need help?
General