Chapter 10. Copy services 543
6. Click Save to confirm your changes.
10.4.11 Renaming FlashCopy mapping
Complete the following steps to rename a FlashCopy mapping:
1. From the main panel, click Copy Services → FlashCopy or Consistency Groups, or
FlashCopy Mappings.
2. In the table, select the FlashCopy mapping that you want to rename.
3. Click Actions → Rename Mapping, as shown in Figure 10-60.
Figure 10-60 Rename Mapping action
4. In the Rename FlashCopy Mapping window, enter the new name that you want to assign
to the FlashCopy mapping and click Rename, as shown in Figure 10-61.
Figure 10-61 Renaming a FlashCopy mapping
Note: Cleaning Rate: This option minimizes the amount of time that a mapping is in the
stopping state. If the mapping is not complete, the target volume is offline while the
mapping is stopping.
For FlashCopy background cleaning rates, starting from V7.8.1, IBM Spectrum
Virtualize software allows the background cleaning rate up to 2 GBps.
Tip: You can also right-click a FlashCopy mapping and select Rename Mapping.
FlashCopy mapping name: You can use the letters A - Z and a - z, the numbers 0 - 9,
and the underscore (_) character. The FlashCopy mapping name can be 1 - 63
characters.
To Next Page
Loading...
Need help?
General