Chapter 5. Host configuration 253
3. The system waits until you apply the changes that you made. Click Apply Changes. All
changes are applied, as shown in Figure 5-61.
Figure 5-61 Applying all iSCSI changes
4. The Configuration window (Figure 5-60 on page 252) shows an overview of all of the
iSCSI settings for the IBM Storwize V5000. You can configure the iSCSI alias, Internet
Storage Name Service (iSNS) addresses, Challenge Handshake Authentication Protocol
(CHAP), and the iSCSI IP address, which we also edit in the basic setup.
5. Click Ethernet Ports to enter the iSCSI IP address (Figure 5-62). Repeat this step for
each port that you want to use for iSCSI traffic.
Figure 5-62 Enter an iSCSI IP address
6. After you enter the IP address for each port, click Modify to enable the configuration.
Note: We advise that you reserve at least one port for the management IP address.
Typically, reserve Port 1 for the management IP address and configure Port 2 for iSCSI.
In our example, we use Port 1 due to limited cabling.
To Next Page
Loading...
Need help?
General