To Next Page

To Previous Page

Chapter 6. Volume configuration 319

2. Next, in the Volume Details subsection you can input the Quantity, Capacity (virtual),

Capacity Savings (choose Compressed from the drop-down menu), and Name of the

volume being created as shown in Figure 6-31.

Figure 6-31 Volume Details

3. Next, in the Compressed subsection enter the real either in terms of % of virtual capacity

or in GiB, expansion criteria, warning threshold and desired % of the virtual capacity at

which you should receive a warning as shown in Figure 6-32.

Figure 6-32 Compressed details

4. Next, in the General sub-section enter the caching mode as Enabled, Read-only or

Disabled as shown in Figure 6-33. Also enter unit device identifier (UDID) if this volume is

going to be mapped to an OpenVMS host.

Figure 6-33 General details

Other manuals for IBM Storwize V5030

Questions and Answers:

Need help?

Do you have a question about the IBM Storwize V5030 and is the answer not in the manual?

General