IBM Storwize V5030 User Manual

810 Implementing the IBM Storwize V5000 Gen2 with IBM Spectrum Virtualize V8.1
Configuring the SSH client
Before you can use the CLI, you must configure the SSH client:
1. Start PuTTY. The PuTTY Configuration window opens (Figure A-12).
Figure A-12 PuTTY
In the right pane, select SSH as the connection type. Under the “Close window on exit”
section, select Only on clean exit, which ensures that if any connection errors occur, they
are displayed on the user’s window, see Figure A-13.
Figure A-13 Select SSH + Only on clean exit

IBM Storwize V5030 Specifications

General

Model	IBM Storwize V5030
Category	Storage
Controller Enclosures	1 or 2
Maximum Drives	240
RAID Levels	0, 1, 5, 6, 10
Virtualization	Yes
Data Compression	Yes
Maximum Hosts	512
Form Factor	2U
Drive Types	SAS, NL-SAS, SSD
Host Interface	8 Gb FC, 16 Gb FC, 10 Gb iSCSI, 12 Gb SAS
Processor Cores	8 per controller