Icom IC-7700 - Autotune Function

■ Autotune function
The Automatic tuning function tunes the displayed
frequency(maximumCW:±500Hz,AM:±5kHz)au-
tomatically when an off-frequency signal is received.
This function is active while in CW or AM mode is se-
lected.
➥ Push [AUTOTUNE] to toggle the autotune function
ON or OFF.
 •
“
AUTOTUNE
”
blinks when autotune function is acti-
vated.
 •After2seconds haspassed,theautotune function
stops tuning automatically even it’s still off-frequency.
IMPORTANT!
When receiving a weak signal, or receiving a sig-
nal with interference, the automatic tuning function
may tune the receiver to an undesired signal.
Appears
AUTOTUNE
AUTO
TUNE