Icom IC-7700

7-2
7
VOICE RECORDER FUNCTIONS
■ Recording a QSO audio
■ Recording quick operation
TheVoicerecorderfunctionrecordsaQSO(communi-
cation) audio onto a USB flash drive.
This function enables you to record both received and
transmitted audio, a QSO with a DX’pedition, and play-
back the recorded audio after the QSO.
D To start or stop recording
EXIT/SET
F-2
QSO REC
q Push
EXIT/SET
several times to close a multi-func-
tion screen, if necessary.
wPush[VOICE]
F-2
todisplaytheVoiceRecorder
menu.
e Hold down [QSO REC]
F-4
for 1 second to start
voice recording.
 •The “ ” indicator appears and the “
USB
” indicator
blinks.
 •Recordingiscontinuousuntilyoumanuallystoprecord-
ing, or the USB flash drive becomes full.
 •If the recording le’s content reaches 2GB, the trans-
ceiver automatically creates a new le, and continues
recording.
 •The“
” indicator appears instead of the “ ” indicator
while recording is paused.
r Hold down [QSO REC]
F-4
for 1 second to stop
recording.
 •The“ ” indicator disappears and the “
USB
” indicator
stops blinking.
t Push
EXIT/SET
toexittheVoiceRecorderscreen.
D To start or stop recording
REC
q Hold down
REC
for 1 second to start voice record-
ing.
 •The “ ” indicator appears and the “
USB
” indicator
blinks.
w Hold down
REC
for 1 second again to stop record-
ing.
Convenient! ✓
When the PTT Automatic Recording function is set to
ONintheVoicesetmode,therecordingautomatically
starts when you push [PTT]. (p. 7-14)
NOTE:
•Be sure to connect a USB ash drive before re-
cording a QSO audio.
• Once recording starts, it continues, even if the
transceiver is turned OFF and then ON again.