Icom IC-7700 - ACC Set Mode for Input;Output Levels

12-7
12
SET MODE
■ ACC set mode
ACC AF Output Level 50
%
Sets the desired audio output level, output from
[ACC1], within 0 to 100% in 1% steps.
•Outputsapproximately200mVat50%(default)setting.
S/PDIF Output Level 100
%
Sets the desired output level of [S/P DIF], within 0 to
100% in 1% steps. (default: 100%)
ACC MOD Level 50
%
Sets the desired audio input level for modulation
from [ACC1].
•Approximately100mVat50%(default)setting.
S/PDIF MOD Level 50
%
Sets the desired input level for modulation from [S/P
DIF], within 0 to 100% in 1% steps.
(default: 50%)
LAN MOD Level 50
%
Sets the desired input level for modulation from
[LAN], within 0 to 100% in 1% steps.
(default: 50%)
DATA OFF MOD MIC,ACC
Selects the desired connector(s) for modulation
input when data mode is not in use.
•MIC :Usethesignalsfrom[MIC].
•ACC :Usethesignalsfrom[ACC1](pin4).
•MIC,ACC :U se th e s ign als f rom [ MIC ] a nd
[ACC1] (pin 4). (default)
•S/PDIF :Usethesignalsfrom[S/PDIF].
•LAN :Usethesignalsfrom[LAN].
DATA1 MOD ACC
Selects the desired connector(s) for modulation
input when data 1 mode (D1) is in use.
•MIC :Usethesignalsfrom[MIC].
•ACC :Usethesignalsfrom[ACC1](pin4).
(default)
•MIC,ACC :U se th e s ign als f rom [ MIC ] a nd
[ACC1] (pin 4).
•S/PDIF :Usethesignalsfrom[S/PDIF].
•LAN :Usethesignalsfrom[LAN].