Icom IC-7700

9-6
■ Memory scan operation
q Push
EXIT/SET
several times to close a multi-func-
tion screen, if necessary.
w Select memory mode.
e Push [SCAN]
F-5
to select the scan screen.
r Set [SQL] open or closed.
 •Seepage9-2forsquelchcondition.
t Push [MEMO]
F-1
to start the memory scan.
 •“
MEMORY SCAN
” and decimal points blink while scan-
ning.
y When the scan detects a signal, the scan stops,
pauses or ignores it depending on the resume set-
ting and the squelch condition.
u To cancel the scan, push [MEMO]
F-1
.
 •Rotatingthemaindialalsocancelsthescan.
2 or more memory channels must be programmed
for memory scan to start.
■ Select memory scan operation
q Push
EXIT/SET
several times to close a multi-func-
tion screen, if necessary.
w Select memory mode.
e Push [SCAN]
F-5
to select the scan screen.
r Set [SQL] open or closed.
 •Seepage9-2forsquelchcondition.
t Push [SEL No.]
F-5
several times to select the
select scan number from ★1, ★2, ★3 and ★1,2,3.
y Push [MEMO]
F-1
to start the memory scan.
 •“
MEMORY SCAN
” and decimal points blink while scan-
ning.
u Push [SELECT]
F-3
to start select memory scan;
push [SELECT]
F-3
again to return to memory
scan, if desired.
 •“
SELECT MEMORY SCAN
” b l i n k s i n s t e a d o f
“
MEMORY SCAN
” during select memory scan.
i When the scan detects a signal, the scan stops,
pauses or ignores it depending on the resume set-
ting and the squelch condition.
o To cancel the scan, push [MEMO]
F-1
.
 •Rotatingthemaindialalsocancelsthescan.
2 or more memory channels must be designated
as select memory channels, as well as the same
select scan channel number, for select memory
scan to start.
[SQL]
Main dial
EXIT/SET
F-1
MEMO
F-3
SELECT
F-5
SEL No.
[SQL]
Main dial
EXIT/SET
F-1
MEMO
9
SCANS