Icom IC-7700

7-11
7
VOICE RECORDER FUNCTIONS
■ Sending a recorded message
D Single TX
F-1
T1
F-2
T2
F-3
T3
F-4
T4
F-7
T/R
EXIT/SET
q Push
EXIT/SET
several times to close a multi-func-
tion screen, if necessary.
w Select a phone mode by pushing
SSB
or
AM/FM
.
ePush[VOICE]
F-2
 to enter the Voice recorder
menu.
r Push [PLAY]
F-1
 to enter the Voice recorder
screen.
 •Ifthereceivevoicemessageappears,push[T/R]
F-7
to select TX message (T1–T4).
t Push a desired message switch, [T1]
F-1
to
[T4]
F-4
, to transmit the contents.
Appears
Counts down
  •Thetransceivertransmitsautomatically.
 •“
SEND
” indicator appears and the memory timer
counts down.
 •Youhearthetransmittedmessagefromthespeakeras
the default. This can be turned OFF in voice set mode.
(p. 7-13)
y Push the selected message switch, [T1]
F-1
to
[T4]
F-4
, again to stop, if desired.
 •Thetransceiverreturnstoreceiveautomaticallywhenall
of the recorded contents in the message are transmit-
ted.
u Push
EXIT/SET
 twice to exit the voice memory
screen.
D Repeat TX
F-1
T1
F-2
T2
F-3
T3
F-4
T4
F-7
T/R
EXIT/SET
q Perform steps q to r above.
w Hold down a desired message switch, [T1]
F-1
to
[T4]
F-4
, for 1 second to repeatedly transmit the
recorded voice audio for up to 10 minutes at the
interval specified in “Repeat Time.”
 •Evenif10minutespasswhiletransmitting,thevoice
audio is completely transmitted.
 •Oneofthefollowingstepswillcancelthetransmission.
- Push the memory again.
  -Pushanothermemory(exceptfor[TXLEV.]).
Appears Repeat indicator
  -ExittheTXVoicememoryscreen.
- Turn OFF the power, then turn it ON again.
- Activate the transmission.
The repeat transmission is cancelled. But while trans-
mitting, the voice audio is completely transmitted.
 •OncetheRepeatTXismade,thetransceiverpauses
until the end of the “Repeat Time,” then transmits again.
After the second transmission, the Repeat TX continues
pausing, if receiving a signal. But if the squelch is manu-
ally opened, the voice audio is repeatedly transmitted,
according to the repeat time setting.
✔ For your convenience
WhenanexternalkeypadorPCkeyboardisconnected,therecordedmessage,T1toT4,canbetransmitted
withoutopeningtheVoiceRecorderscreen.Seepages2-6,2-7and12-17fordetails.
•Therecordedmessage,T1toT4istransmittedoncewhenpushingoneoffourswitchesontheexternalkeypad;there-
corded message is repeatedly transmitted when holding down a switch.
•Therecordedmessage,T1toT4istransmittedoncewhenpushingoneof[F1]to[F4]keyonthePCkeyboard;there-
corded message is repeatedly transmitted when pushing a key while holding down [SHIFT] key.