Icom IC-7700

•IC-PW1/EURO
h f /50 m h z a l l b a n d 1 k w l i n e a r a m p l i f i e r
Full-duty-cycle 1 kW linear amplifier including an
automatic antenna tuner. Has automatic tuning and
band selection capability when used with an Icom
transceiver. Full break-in (QSK) operation. The
amplifier/power supply unit and the remote control
unit can be separately installed.
•SM-50 d e s k t o p m i c r o p h o n e
Unidirectional, dynamic
microphone for base sta-
tion operation. Includes
[UP]/[DOWN] switches, a
low cut switch and mic gain
control.
15-4
■ Options
15
SPECIFICATIONS AND OPTIONS
•SM-30 d e s k t o p m i c r o p h o n e
Unidirectional, electret micro-
phone for base station opera-
tion. Includes low cut switch
and mic gain control.
SP-34 e x t e r n a l s p e a k e r
4 audio filters; headphone jack; can connect to 2 transceiv-
ers.
•Inputimpedance :8Ω
•Max.inputpower :5W
•HM-36 h a n d m i c r o p h o n e
Hand microphone equipped
with [UP]/[DOWN] switches.
•CT-17 c i -v l e v e l c o n v e r t e r
This unit converts signal levels from RS-232C data
totheserialCI-Vdata.Thiscanbeusedforremote
transceiver control using PC. You can change fre-
quencies, operating mode, memory channels, etc.
(software is not included)
Approved Icom optional equipment is designed for optimal performance when used with an Icom transceiver.
Icom is not responsible for the destruction or damage to an Icom transceiver in the event the Icom transceiver is
used with equipment that is not manufactured or approved by Icom.
SP-33 e x t e r n a l s p e a k e r
Designed for base station operation.
•Inputimpedance :8Ω
•Max.inputpower :5W
RS-BA1 ip r e m o t e c o n t r o l s o f t w a r e
To remotely control radios using the RS-BA1, BE SURE
that you comply with your local regulations.