Icom IC-7700

8-3
8
MEMORY OPERATION
■ Memory channel programming
Memory channel programming can be preformed ei-
therinVFOmodeorinmemorymode.
D Programming in VFO mode
q Set the desired frequency, operating mode and fil-
terwidthinVFOmode.
w Push
∫
/
√
several times to select the de-
sired memory channel.
 •Memorylistscreenisconvenientforselectingthede-
sired channel.
 •Memorychannelcontentsappearinthememorychan-
nel readout (below the frequency readout).
 •“--.---.--”appearsiftheselectedmemorychannelisa
blank channel (and does not have contents).
e Hold down
MW
for 1 second to program the
displayed frequency, operating mode, etc., into the
memory channel.
D Programming in memory mode
q Select the desired memory channel with
∫
/
√
in memory mode.
 •Memorychannelcontentsappearinthememorychan-
nel readout (below the frequency readout).
 •“--.---.--”appearsiftheselectedmemorychannelisa
blank channel (and does not have contents).
w Set the desired frequency and operating mode in
memory mode.
 •Toprogramablankchannel,usedirectfrequencyentry
with the keypad or memo pads, etc.
e Hold down
MW
for 1 second to program the
displayed frequency and operating mode into the
memory channel.
MW
Y Z
or
Hold down for 1 sec.
Beep
Beep
Beep
MW
SSB
[EXAMPLE]:
Programming 7.088 MHz/LSB into memory channel 12.
or then
Hold down for 1 sec.
Beep
Beep
Beep
7
21
MW
SSB
[EXAMPLE]:
Programming 21.280 MHz/USB into memory channel 18.