7-14
7
VOICE RECORDER FUNCTIONS
Select the recording mode for recording a QSO
audio.
•TX&RX:Recordsboththetransmittedandreceived
audio.
•RXonly:Recordsonlythereceivedaudio.
RX REC Condition Squelch Auto
Select whether or not the squelch status affects the
RX voice audio recording.
•Always: Thetransceiveralwaysrecordsthe
RX audio, regardless of the squelch
status.
•SquelchAuto:ThetransceiverrecordstheRXaudio
only when a signal is received (the
squelch is opened).
When the squelch closes while re-
cording, the recording will continue
for 2 seconds, and then pause.
Turn the File Split function ON or OFF. •OFF:Theaudioiscontinuouslyrecordedintothe
file, even if you switch between transmit and
receive or the squelch status changes be-
tween open and closed.
•ON: Whilerecording,andifyou switchbetween
transmit and receive, or the squelch status
changes between open and closed, a new file
is automatically created in the same folder,
and the audio is saved into the new one.
Turn the PTT Automatic Recording function ON or
OFF.
•OFF:Therecordingdoesnotstartevenifasignalis
transmitted.
•ON: Therecordingautomaticallystartswhenasig-
nal is transmitted.
The recording will continue when:
•Asignalistransmittedagainwithin10seconds
after the last transmission.
•Asignalisreceivedwithin10secondsafterthe
last transmission, the received audio is also re-
corded.
- A signal is received within 10 seconds after the
last reception.
•ThesquelchisopenintheFMmodes.
The recording will stop when:
•Thefrequencyoroperatingmodeischanged.
•Theoperatingmethod(V/M,M-CH,BandStack-
ing Register, and so on) is changed.
•10minuteshaspastafterthelasttransmission
while the squelch is open in the SSB, CW, RTTY,
PSK or AM modes.
Set the Skip time for forwarding or rewinding while
playing back the QSO audio.
3, 5, 10 and 30 seconds are selectable.
■ Voice set mode (continued)
To Next Page
Loading...
