Icom IC-7700 - Antenna Memory Settings and Types

10-3
■ Antenna memory settings
This function stores the antenna connector number
for each frequency band.
q Push
EXIT/SET
several times to close multi-function
screen, if necessary.
w Hold down [ANT]
(MF1) for 1 second to select an-
tenna set screen.
e Select the desired frequency band with a band key.
r Push [ANT] (MF1) several times to select the de-
sired antenna number that you want to set for the
selected frequency band.
 •“★” appears.
t Hold down [ANT MW]
F-3
for 1 second to store
the antenna selection into the antenna memory.
 •“★” disappears.
y Repeat the steps e to t to store the antenna se-
lection for another frequency bands, if desired.
u Push
EXIT/SET
toexitantennasetscreen.
D Antenna type selection
When no antenna is connected to [ANT2], [ANT3],
and/or [ANT4], these antenna connectors can be de-
activated — deleting the antenna number from the
available selections. This prevents the transceiver
from accidentally transmitting into an unused antenna
connector. In addition, a receive-only antenna can be
specified for [ANT4].
q Select the antenna set screen as described above.
w Push [ANT TYPE]
F-7
to select antenna type set
screen.
e Push [Y]
F-1
or [Z]
F-2
to select the desired
antenna.
r Rotate the main dial to select the desired antenna
condition from TX/RX, RX (ANT4 only) and OFF.
 •TX/RX :Selectwhenanantennaisconnected.
 •OFF :Selectwhennoantennaisconnected.
 •RX :Selectwhenareceiveonlyantennais
connected.
(available for the [ANT4] only)
t Push
EXIT/SET
toexitantennatypesetscreen.
✔ For your information
The “OFF” antennas cannot be selected with [ANT]
(MF1) switch operation, or with the antenna memory
setting.
When “RX” is selected for [ANT4], “1/R,” “2/R” and
“3/R” selections will be added for the selection for
both [ANT] (MF1) switch operation and the antenna
memory setting. In these selections, the antenna con-
nected to [ANT1], [ANT2] and/or [ANT3] will be used
for transmission and the antenna connected to [ANT4]
will be used for reception.
Band keys
ANT
F-3
ANT MW
F-1
∫
F-2
√
F-7
ANT TYPE
10
ANTENNA TUNER OPERATION