Icom IC-7700 - File Loading

12-27
12
SET MODE
■ File loading
By loading the saved setting file from the USB flash
drive, you can easily set up another IC-7700—several
operators settings can easily be applied to one IC-
7700.
q During set mode menu screen display, push
[USB]
F-7
to select USB-Memory set menu
screen.
w Push [LOAD]
F-1
to select setting load screen.
 •TheindicatorabovetheUSBconnectorsand“USB”
indicator on the display blink.
 •AftertheUSBflashdrivecontentsaredisplayed,the
indicators stop blinking.
e Push [OPTION]
F-5
to select load option set
mode, then set the desired loading conditions, if
desired.
 •Seepage12-25fordetails.
r Push [Y]
F-2
or [Z]
F-3
to select the desired
setting file.
t Push [LOAD]
F-4
.
 •Confirmationscreenappears.
y Push [OK]
F-6
to starts loading.
 •Aftertheloadingiscompleted,themessagedialog,
“Reboot the IC-7700,” appears.
u Turn the transceiver power OFF then ON to make
the setting effective.
DIR/FILE
F-1
F-7
WIDE CANCEL
F-5
OPTION
F-6
SORT OK
F-4
LOAD
//
F-2
∫
F-3
√
EXIT/SET