Icom IC-7700 - D Contest Number Set Mode

4-10
D Contest number set mode
This menu is used to set the contest (serial) number
and count-up trigger, etc.
• Setting contents
q During CW mode operation, push [KEYER]
F-3
to select memory keyer screen.
w Push
EXIT/SET
to select memory keyer menu, then
push [001]
F-3
to select contest serial number
set mode.
e Push [Y]
F-1
or [Z]
F-2
to select the desired
set item.
r Set the desired condition using the main dial.
 •Holddown[DEF]
F-4
for 1 second to select the de-
fault condition or value.
• Contest number set mode screen t Push
EXIT/SET
twice to normal screen.
Main dial
F-1
∫
F-2
√
EXIT/SET
F-4
DEF
4
RECEIVE AND TRANSMIT
Number Style Normal
This item sets the numbering system used for con-
test (serial) numbers— normal or short morse num-
bers.
Short morse numbers are also referred to as “cut”
numbers.
•Normal  :Doesnotuseshortmorsenumbers
(default)
•190➔ANO : Sets 1 as A, 9 as N and 0 as O.
•190➔ANT : Sets 1 as A, 9 as N and 0 as T.
•
90➔ NO : Sets 9 as N and 0 as O.
• 90➔ NT : Sets 9 as N and 0 as T.
Count Up Trigger M2
This selects which of the four memories will contain
thecontestserialnumberexchange.Thecount-up
trigger allows the serial number to automatically
incrementaftereachcompleteserialnumberex-
change is sent.
•M1,M2,M3andM4canbeset.(default:M2)
Present Number 001
This item shows the current number for the count-up
trigger channel set above.
•Rotatethemaindialtochangethenumber,orhold
down [001CLR]
F-4
for 1 second to reset the cur-
rent number to 001.