Icom IC-7700

14-13
14
CONTROL COMMAND
D Data contents description (continued)
q, w Memory channel number
0001–0099 : Memory channel 1 to 99
0100 : Programmed scan edge P1
0101 : Programmed scan edge P2
To clear the memory channel contents, add the
code “FF” after the momory channel number. (in-
stead of the data e to @7.
This completes the memory clearing.
e Split setting, Select memory setting
e
XX
0=OFF
1= 1
2= 2
3= 3
0=Split OFF
1=Split ON
When setting the programmed scan edges P1 or P2,
you must select OFF for both settings.
r–i Operating frequency setting
See“•Operatingfrequency.”
o, !0 Operating mode setting
See“•Operatingmode.”
!1 Data mode and tone type settings
XX
!1
0: OFF, 1: TONE, 2: TSQL
0: OFF, 1: DATA 1, 2: DATA 2, 3: DATA 3
!2–!4 Repeater tone frequency setting
!5–!7 Tone squelch frequency setting
See“•Repeatertone/tonesquelchsetting.”
!8–@7 Memory name setting
Up to 10 characters.
See“•Codesformemoryname,openingmessage
and Clock 2 name contents.”
• Memory content setting
Command : 1A 00
X
er−i
r−!7:
r−!7
r−!7.
o, !0 !1 !2−!4 !5−!7
XXX ... .........XXXXXXXXXXXXXXXXXXXXXX XX XX XX
q, w !8−@7
Are programmed in the same manner as
When the split setting is ON, these settings are the matching transmit settings.
Even when the split setting is OFF, these settings are still necessay.
Be sure the settings are compatible with the specifications of the IC-7700.