POC-W24C-ULT3 FHD Medical Panel PC
Page 104
6.1 System Maintenance Introduction
If the components of the POC-W24C-ULT3 fail they must be replaced. Please contact the
system reseller or vendor to purchase the replacement parts.
6.2 Anti-static Precautions
WARNING:
Failure to take ESD precautions during the maintenance of the
POC-W24C-ULT3 may result in permanent damage to the
POC-W24C-ULT3 and severe injury to the user.
Electrostatic discharge (ESD) can cause serious damage to electronic components,
including the POC-W24C-ULT3. Dry climates are especially susceptible to ESD. It is
therefore critical that whenever the POC-W24C-ULT3 is accessed internally, or any other
electrical component is handled, the following anti-static precautions are strictly adhered
to.
Wear an anti-static wristband: - Wearing a simple anti-static wristband can
help to prevent ESD from damaging the board.
Self-grounding: - Before handling the board touch any grounded conducting
material. During the time the board is handled, frequently touch any
conducting materials that are connected to the ground.
Use an anti-static pad: - When configuring the POC-W24C-ULT3, place it on
an anti-static pad. This reduces the possibility of ESD damaging the
POC-W24C-ULT3.
Only handle the edges of the PCB: - When handling the PCB, hold the PCB
by the edges.
To Next Page
Loading...
Need help?
General
