POC-W24C-ULT3 FHD Medical Panel PC
Page 38
3.11.1 Wall Mounting
To mount the medical panel PC onto the wall, please follow the steps below.
Step 1: Select the location on the wall for the wall-mounting bracket.
Step 2: Carefully mark the locations of the four screw holes in the bracket on the wall.
Step 3: Drill four pilot holes at the marked locations on the wall for the bracket retention
screws.
Step 4: Align the wall-mounting bracket screw holes with the pilot holes.
Step 5: Secure the mounting bracket to the wall by inserting the retention screws into
the four pilot holes and tightening them (
Figure 3-24).
Figure 3-24: Wall-mounting Bracket
Step 6: Insert the four monitor mounting screws provided in the wall mount kit into the
four screw holes on the real panel of the medical panel PC and tighten until the
screw shank is secured against the rear panel (
Figure 3-25).
To Next Page
Loading...
Need help?
General
