Infinity Chimp 100 - Recording Fixture Groups; Storing a Fixture Group Using Group Split Widget; Storing a Group Using Command Line Interface; Merge (Add) Fixtures into Groups

112
Infinity Chimp Series
Infinity Chimp Series
Recording Fixture Groups
To record your first group, start out by selecting fixtures 1 through 12 by using the Keypad (refer to 15.1
Selecting Fixtures on page 101 for more information).
Storing a Fixture Group Using Group Split Widget
● Select the fixtures that shall be in the group
● Open a Group Split Widget by clicking on the Groups button in one of the side menus.
● Hit the [Rec] key. Select an empty item.
● Select the fixtures that shall be in the group
Storing a Group Using Command Line Interface
● Select the fixtures you wish to group together
● Press the [Rec] key
● Press the [Group] keypad button.
● Now, type the number of the item using the Numberblock
● Press [Enter]
For example: [Rec] [Group] [1] [Enter]
Merge (Add) Fixtures into Groups
Sometimes you may need to add some fixtures to a group that already exists.
The confirmation dialog may be omitted by selecting the Merge option from the record toolbar after
pressing record.
Alternatively, you can also press [Infinity] while pressing [Rec] to cycle through the different record
modes.
Merge Fixture(s) into Group using Group Split Widget
● Select the fixtures you would like to add to an existing group.
● Open a Group Split Widget by clicking on the Groups button in one of the side menus.
● Hit the [Rec] key on the consoles frontpanel.
● Select the Group you would like to merge the selected fixtures into.
● If you did not select an option from the Record-Toolbar, a dialog window asking you what to do will
open.
● Click on Merge.
Merge Fixture(s) into Group using the Commandline Interface
● Select the fixtures you would like to add to an existing group.
● Press the [Rec] key, followed by the [Group] key.
● Now type the number of the group you would like to add the Fixtures to on the console’s keypad, in
example, [1] followed by [Enter].
● If you did not select an option from the Record-Toolbar, a dialog window asking you what to do will
be shown. Click on Merge.
Remove Fixtures from Groups
The confirmation dialog may be omitted by selecting the Remove option from the record toolbar after
pressing record.