169
Clicking on the Display Usage button will open a dialog showing you information about how and where
this preset Is used.
Merge to Programmer
Clicking on the Merge to Programmer button will load the presets contents without referencing to the
preset into the programmer. Content that already exists in the programmer will only be overridden if the
preset contains any information for the same attributes. This will load values for all fixtures the preset
contains values for and will select all these fixtures.
Load to Programmer
Clicking on the Load to Programmer button will load the presets contents without referencing to the
preset into the programmer. Content that already exists in the programmer will be deleted and replaced
by the presets content. This will load values for all fixtures the preset contains values for and will select all
these fixtures.
To Next Page
Loading...
