Infinity Chimp 100 - Alter Fixture Parameters; Altering Intensity (Dimmer Values) Using Keypad

124
Infinity Chimp Series
Infinity Chimp Series
Alter Fixture Parameters
Altering Intensity (Dimmer Values) Using Keypad
Dimmer Levels may be applied directly to selected fixtures using the keypad by typing [@] followed by
either [Full] or the intensity value (in percent) followed the [Enter] key.
The syntax also allows for:
[@] [Full]
Will set the selected fixtures to 100%
[@] [@]
Will set the selected fixtures to 100%
[..]
Will set the selected fixtures to 0%
[@] [.] [Value]
Will set the selected fixtures Intensity DMX Value to
[Value]
[@] [+] [Value]
Will increment the current value by
[Value]
[@] [-] [Value]
Will decrement the current value by
[Value]
[+] [+]
Will increment the Value by 10%
[-] [-]
Will decrement the Value by 10%
[Full]
Will set the selected fixtures to 100%
[Value A] [Thru] [Value B]
Will fan the Intensity for selected fixtures from [Value
A] to [Value B] In Example:
[0] [Thru] [100]
with 3 selected fixtures will set
fixture 1 to 0%, fixture 2 to 50% and fixture 3 to 100%.
[Value A] [Thru] [Thru]
[Value B]
Will fan the Intensity for selected fixtures from [Value
A] to [Value B] and back to [Value A]. In
Example:
[0] [Thru] [Thru] [100]
with 5 selected fixtures
will set fixture 1 and 5 to 0%, fixture 2 and 4 to 50%
and fixture 3 to 100%.