117
Create a Group Dimmer Master
Group Dimmer Masters allow you to limit the intensity of a specific fixture group. If the Group Master is at
full, then the fixtures that this group contains will be at the level determined by the playbacks,
Programmer, and so on. When the master’s level is reduced, the contained fixtures intensity will be
reduced in proportion to the master. For example, if you have the fixture at 80% intensity in a cue that is
being output, and the master of the group is at 50%, a fixture intensity value of 40% will be output.
Multiple Group Dimmer Masters are compared HTP, so the highest master will take precedence.
There are two ways to assign a Group Dimmer Master:
Using the Group Split Widget Window
● Select Groups from a split widgets side menu.
● Hit the [Link] key.
Now select the Group from within the Split Widget followed by the [Go], or [Pause/Back] key of the
fader that should act as the Dimmer Master.
Using the Command Line Interface
● Press the [Link] key
● Press the Group key and the appropritate ID of the group, in example: [Group] [1].
● Now select the [Go], or [Pause/Back] key of the fader that should act as the Dimmer Master.
To Next Page
Loading...
