177
● Press the [Cuelist] key.
● Type the number of the cuelist you would like to update a cue from to - i.e., [1].
● Press the [Cue] key.
● Type the number of the cue you would like to update - i.e., [1].
● Press [Enter] to execute the command.
If the cuelist is selected, you can simply:
● Touch the attributes you would like to remove
● Press the [Rec] key
● Make sure the the Replace option from the record toolbar is selected.
● Type the number of the cue you would like to update - i.e., [1].
● Press [Enter] to execute the command.
Inserting a Cue
Make sure the the Insert option from the record toolbar after pressing [Rec] is selected.
Alternatively, you can also press [Infinity] while pressing [Rec] to cycle through the different record
modes.
Insert a Cue in between other cues using the User Interface
● Touch the attributes you would like to record
● Press the [Rec] key
● Make sure the the Insert option from the record toolbar is selected.
● A window will be opened asking you to select the Cue you would like to insert the new one in front
of.
● Click on Insert after selecting the appropriate Cue.
Insert a Cue in between other cues using the Command Line
● Touch the attributes you would like to record
● Press the [Rec] key
● Press the [Cuelist] key.
● Type the number of the cuelist you would like to insert a cue into - i.e., [1].
● Press the [Cue] key.
● Type the number of the new cue - i.e., [1.5].
● Press [Enter] to execute the command.
If the cuelist is selected, you can simply:
● Touch the attributes you would like to remove
● Press the [Rec] key
● Type the number of the new cue., [1].
● Press [Enter] to execute the command.
To Next Page
Loading...
