180
Loading a Cue to the Programmer
Sometimes it is desirable to load a complete cue into the programmer to edit it.
Load a Cue using the User Interface
● Press the [Load] key on the keypad.
● Now select the appropriate Cuelist by the either a master’s Play or Pause / Back Key, or by selecting
the Cuelist in a Cuelist Split Widget. Alternatively, you may click on the cue displayed in a cuelist
view.
● A window will be opened asking you to select the Cue to be loaded. Click on Load after selecting
the Cue from the list.
● If the cuelist only contains a single cue, this cue will be loaded automatically.
Load a Cue using the Command Line
● Press the [Load] key on the keypad.
● Press the [Cuelist] key.
● Type the number of the cuelist you would like to load a cue from - i.e., [1].
● Press the [Cue] key.
● Type the number of the cue - i.e., [1.5].
● Press [Enter] to execute the command.
If the cuelist is selected, you can simply:
● Press the [Load] key
● Type the number of the cue., [1].
● Press [Enter] to execute the command.
Assigning Cuelists to Masters
Assigning a Cuelist to a Master / Executor Using Cuelist Split Widget
To assign a Cuelist (in the Cuelist Pool) to a Master:
● press the [Link] key
● Tap on the Cuelist you would like to assign to the master
● Press the master’s Play or Pause / Back Key or an Executor Button
Assigning a Cuelist to a Master / Executor Using Command Line Interface
● Press the [Cuelist] key
● Type the number of the Cuelist, you would like to assign i.e., [1].
● Then press the desired master’s or Pause / Back Key or an Executor Button.
To Next Page
Loading...
