Intec CS4000 - Page 75

- 142 - - 143 -
Windows utilities Windows utilities
4
5
1
3
2
4
5
1
2
3
Convenient print
functions
Appendix Index
Checking and
Changing Printer
Settings Using
the Control Panel
Network
Setup
Matching
Colors
Using Utility
Software
Convenient print
functions
Appendix Index
Checking and
Changing Printer
Settings Using
the Control Panel
Network
Setup
Matching
Colors
Using Utility
Software
Device Info tab
You can view the Intec device status and
advanced information.
This function is available with the Conguration
Tool as standard.
1
Click the Intec device whose information
you want to view from "Registered
Device Table".
The Intec device status will be displayed.
Memo
z
To change the information, click [Update Device
Information].
Note
z
The device status will be displayed if an Intec device
is connected to the network.
Network Setting plug-in
The network can be set using the Conguration
Tool. Before making the settings, install the
Network Setting plug-in.
Reference
z
For how to set up the network, see the "Basic".

Icon types
The icon meanings are described below.
Icon Explanation
Searches for the device again.
Changes the search conditions.
Changes the device IP address.
Restarts the device.
Changes the network password.
Displays the web page for the
specied device.

Searching for devices on the
network
You can search for devices.
1
Select [Network Setting] from the
[Plug-ins] menu.
2
Select [Discover Devices].
The search results will be displayed.
Registering devices
When using the Conguration Tool for the rst
time or introducing a new Intec device, register
the Intec device in the Conguration Tool.
1
Select [Start]>[All programs]> [Intec
Printing Solutions]>[Conguration
Tool]> [Conguration Tool] to start the
Conguration Tool.
2
Select "Register Device" in the "Tools"
menu to search for Intec devices that
can be registered.
Memo
z
To change the scope of the search, select
"Environment Settings" in the "Tools" menu, and
enter the range to be searched. Enter the range,
and click [OK].
3
Enable the check box for the Intec
device to be set and managed, and click
[Register].
4
Click either or [Cancel] in the upper
right of the window to close the
"Register Device" window.