Storm³
Service Manual
Page 36 As at:07.03.02
Lay the vehicle down on its side on a relatively firm underlay, or place wooden blocks
under the frame so that the castor wheels are not loaded.
9.1.7 Replacing the drive wheels
Only use original tyres, see spare parts catalogue!
• Unscrew all Allen screws (1).
• Remove the drive wheel from the wheel hub and replace.
• When reassembling the drive wheel Allen keys, secure
using Loctite (e.g. 243).
Caution: do not loosen the central nut!
Caution:
Risk of accidents: Before the next stage you must remove the valve cap and
depressurise the tyre by pushing in the valve seat. When working with puncture-proof
tyres, ensure that the tyre sealing fluid does not run out (valve should be pointing
upwards)
Red valve caps indicate puncture-proof tyres - black valve caps indicate pneumatic
tyres.
9.1.8 Replacing wheel rim halves
• Remove the drive wheel (see above).
• Unscrew all Allen screws (2) and remove both wheel rim
halves from the tyre.
• Remove wheel rim halves and replace.
9.1.9 Repairing / replacing tyres or inner tube
• Remove the drive wheel (see above).
• Unscrew all Allen screws (2).
• Remove the tyre with inner tube from the wheel rim halves.
• Repair inner tube or tyre and replace, or insert new.
Note:
If the old inner tube is to be repaired and re-used, and has become wet during repair,
you can make replacement easier by sprinkling the inner tube with a little talcum
powder.
"
To Next Page
Loading...
