iPECS UCP
Hardware Description and Installation Manual Issue 1.3
46
on. Do not place wiring under carpets.
Avoid using the same power supply outlet for computers, fax machine, and other office
equipment to avoid induction of electrical noise into the system resulting in poor audio
quality or static.
The power and battery switches must be OFF during wiring. Further, while wiring, power
must not be connected to the cabinet or modules. After wiring is completed, the power
can be connected and the power switch may be turned ON.
Incorrect wiring may cause the iPECS UCP System to operate improperly.
If an extension does not operate properly, disconnect the telephone from the extension
line and then re-connect, or turn the System power OFF and then ON again.
4.1.4 Checking Power cord
Checking the power cord at least once a year to prevent fire hazard or electric shock.
Be sure to disconnect the power cord from the wall outlet and System’s inlet for the following
symptoms:
1. Burn marks on the plug.
2. The prongs on the plug are deformed.
3. The power cord’s inner wires are exposed, broken, etc.
4. The power cord’s coating has a crack.
5. The power cord is overheating.
6. The power cord is damaged.
If the above symptoms find, do not use the power cord and consult your dealer or service
representative.
The following is the simple guide to avoid the hazard or disaster:
1. Make sure Power cord is properly rated for their intended use, indoor or outdoor,
and meet or exceed the power needs of the system being used.
2. Inspect cords for damage before use. Check for cracked or frayed sockets, loose or
bare wires, and loose connections.
3. Never use a cord that feels hot or is damaged in any way.
4. Insert plugs fully so that no part of the prongs is exposed when the power cord is in
use.
Make sure that the power cord is connected to the system firmly, and then connect the plug to the
wall outlet.
To Next Page
Loading...
