iPECS UCP
Hardware Description and Installation Manual Issue 1.3
48
phones and terminals. If existing cabling is employed, the location of existing cabling and
conduits should be considered.
The location should have adequate accessibility, space and lighting for future servicing
and should consider the need for future expansion.
The site should be away from radio transmitting equipment, arc-welding devices, copy
machines, and other electrical equipment capable of generating high levels of electrical
interference. The system should be protected from flooding and heavy machinery as well
as excessive dust and vibration.
Also, if installing DECT, locate the best-estimated position for the Base Stations. The
permanent location of the Base Station will be determined using the GDC-600BTE CSR
Tool to perform a RF coverage survey.
4.3.2 Verify Equipment On-site
Once the equipment installation site has been identified and a dedicated AC outlet, protective
earth ground, lighting and ventilation are available, verify that all equipment and tools required are
on-site and the equipment has not been damaged during shipment. Assure there is no shipping
damage. Check that the type and quantity of Modules and terminals received are correct. Also,
assure any optional equipment and a Power Line Surge Protector are on-site. The individual
Modules and terminals need not be unpacked at this time.
If any equipment appears damaged or missing, notify appropriate personnel to correct the
situation.
To Next Page
Loading...
