ITW SIMCO ION Manager IQ Easy - Page 53

ManagerIQEasy_UM_9752103002_GB_V3_1 52
Fieldbus BusError (*)
0x00
Error code if there are problems with the Fieldbus
module or the network. The code 0x00 indicates
that there is no error or fault; every other value
indicates that a problem was found during the
initialisation of the Fieldbus module. Contact your
Simco-Ion to solve this problem.
Fieldbus Control (*)
0x00
Feedback of the Fieldbus ‘Control’ command.
This command is controlled via the PLC to control
Devices in Standby and Run, for example. See
the relevant Fieldbus documentation for explanation
regarding this parameter.
Fieldbus DevRunMode
(*)
0x00000000
Feedback of the Fieldbus ‘DevRunMode’
command. This command is controlled via the
PLC to be able to control Devices separately in
Stand-by and Run. See the relevant Fieldbus
documentation for explanation regarding this
parameter.
Fieldbus Sensor
ports (*)
0
This parameter is used to map the Sensor
Devices present in the system onto the fieldbus
data structure. See also 6.31.5.
Fieldbus PerfIQ
ports (*)
0
This parameter is used to map the Performax IQ
Easy Devices present in the system onto the
fieldbus data structure. See also 6.31.5.
Fieldbus PerfIQ-Ex
ports (*)
0
This parameter is used to map the Performax IQ
Easy Ex Devices present in the system onto the
fieldbus data structure. See also 6.31.5.
Fieldbus TH2 ports (*)
0
This parameter is used to map the ThunderIon2
Devices present in the system onto the fieldbus
data structure. See also 6.31.5.
Fieldbus CMM ports (*)
0
This parameter is used to map the CMM Easy
Devices present in the system onto the fieldbus
data structure. See also 6.31.5.
Fieldbus CM-Tiny ports
(*)
0
This parameter is used to map the CM-Tiny
Devices present in the system onto the fieldbus
data structure. See also 6.31.5.
Fieldbus GenConv
ports (*)
0
This parameter is used to map the IQ-Com
Generator Convertor Devices present in the
system onto the fieldbus data structure. See also
6.31.5.
Device timeout
5 s
Set time before a Device is reported as
Disconnected if communication with the Device is
lost. Please note: If a value of 0 seconds is set, it
will not be detected that a Device is no longer
communicating with the system. This will cause
undesired behaviour of the system. The ‘0 second’
setting is only intended for testing purposes of
Simco Service Engineers.