Section 19 Maintenance & Inspection 19-36
8 Confirm the contents and click "OK".
The following screen may be displayed.
Note
When this popup message is displayed, the chart data is deleted after completion of
sofware update. Re-import the chart after completion of software update.
9 Check the contents and click on [OK].
Installation of the update is started and the following screen is displayed.
Wait for some time until the installation is completed.
Note
This equipment may restart during installation.
At completion of installation, the following screen is displayed.
10 Switch OFF the power supply of this equipment.
11 Restart this equipment.
12 Start ECDIS, and confirm that the software version number has been updated in the
"Software" tab by selecting [Maintenance] - [System Information].
To Next Page
Loading...
Need help?
General
