Chapter 5 VARIOUS FUNCTIONS
12
5.35.3 STANDBY TIME
Set the time for standby state. Use the cross key or the MULTI control to change the value.
The standby time can be adjusted between 1 and 99 min.
Note:
If you execute function of the Timed TX, please be careful.
Because if you forget to execute the Timed TX, you will misunderstand that radar transmitting was stopped
and radar echo disappeared in the transmitting. You must be remembered that you had set on function of
Timed TX. Please use Timed TX with caution fully.
5.36 TLL TX "USER2"
This function set whether outputting TLL sentence of ownship position with pressing the User2 key.
The output port of TLL is set at “Adjust Menu/7.COM Port Setting/4.TX Port/2.TLL”.
In case, you set the output port of TLL, show ON/ Off of this function at the next.
Off: Normal TLL sentence outputs from the TX Port as you set.
ON: One TLL sentence of Ownship L/L position outputs from the TX Port as you set with at the time of
pressing the User2 key once.
If another function is allocated “User2 Short Press”, both the assigned function and TLL TX are performed by
pressing the User2 key.
5.37 CERTIFICATION INFORMATION
Display the certification information.
To Next Page
Loading...
Need help?
General
