Chapter 7 INITIAL SETTINGS
1
7.1 LANGUAGE SELECTION
In case of choosing non-understand language, it is able to return to the English menu to input “2364” at the
code input menu. At that time, please reselect the language.
7.2 BEARING ADJUSTMENT
Adjust the bearing so that bearing of the target measured with the ship’s compass matches that of the target
echo on the radar display.
Before adjustment
Measure the bearing of an adequate target (for example, a ship at anchor, a breakwater or a buoy) relative
to own ship’s heading.
Procedure
(1) Radar is set to TX mode.
(2) Adjust GAIN, RAIN and SEA to find the known target on the screen.
(3) Adjust the bearing at the end point to display the target described in “Before adjustment” at the same
direction as measured.
䐠㻌 MULTI control or
cross key
change the value.
ճ Adjust the value so that
the known target is on the set EBL.
䐟 Select 䇾Bearing Adjustment.䇿㻌
known target
㻌
known target
㻌
䐟 Select “Language.” 䐠 Select preferred language.
To Next Page
Loading...
Need help?
General
