JRC JMA-3400 Series - Beacon Setting

Chapter 7 INITIAL SETTINGS
14
9
7.8.3 BEACON SETTING
Set for a JRC Beacon (DGPS receiver). This setting is available only for JRC Beacon receiver (DGPS
receiver).
AUTO: Select an optimum beacon station automatically.
Manual: The beacon frequency and baud rate need to be set manually.
Note: This setting is enabled when “Station Select” is set to ”Manual.”
Select
Automatic/manual selection of stations.
Frequency
Set “beacon frequency.”
Baud Rate
Selection of beacon bit rate.
Send Data㻌
Select each setting item.