JRC jue-87 - Page 108

3-48
Note 1) Message can be sent to up to 5 subscribers whom destination code is same, by moving the
cursor to “Destination code-subscriber’s number and answerback code” then pressing
Enter key (Multi address function).
When the subscriber’s number set to two numbers or more, “*” is displayed at right side of
the number.
Note 2) When the file is not in the IME/DTE memory or the USB drive, the following window is
displayed, press
F10 (“Previous”) key and type the new file name.
Fig.3.8.3b “ERROR” Window
Note 3) Following window is displayed when you carry out the procedure of Step 9, if "characTer
code" is set as "Data". Press
F10 (“Previous”) key when you carry out data transmission.
Fig.3.8.3c “WARNING” Window
Note 4) When the selected LED ID is closed, or the selected LES ID is other than 000～063, 100～
163, 200～263, and 300～363, the following window is displayed.
Press
F10 (“Previous”) key and type the correct LES ID.
Fig.3.8.3d “ERROR” Window
ERROR
The file is missing.
Confirm the file name.
F10:Previous
ERROR
Selected LES does not operate in this ocean.
Confirm the LES ID.
F10:Previous
Warning
Can not display binary text.
F10:Previous