vi
CAUTIONS TO BE USED DURING OPERATION
DANGER
Do not touch any internal parts with your hands or tools to avoid danger of electronic shock.
Immediately after printing, the printing head is still very hot, don’t touch it until it is cool
down.
WARNING
Do not bring JUE-87 (EME) close to the fire, or put it in the fire. It causes the explosion,
generation of heat.
Do not approach the JUE-87 (EME) while transmitting, It transmits microwave and strong
microwave might be cause injury.
If a foreign substances, such as metal fragment, water, liquid and etc., are get into your JUE-87,
turn off the power and contact with the agent you purchased or JRC branches. Continuous
operation may cause fire, electrical shock or malfunction.
Ask maintenance and the adjustment of JUE-87 internal equipment to our sales department or
nearest branch office.
Do not turn on the terminal under the primary power except the specific voltage (mentioned
below).The primary power except the specific voltage may cause fire, electrical shock or
malfunction.
DC+24V (+19.2 V to +31.2 V) (When standard PSU, NBD-904 is used)
Do not adjust the internal circuit or exchange the parts because the internal circuit is adjusted
strictly. When an abnormal operation is found, please contact with our sales department or nearest
branch office.
Do not check or repair the internal equipment of JUE-87 by yourself.
Any electrical work by any person other than our specialized maintenance persons may cause fire
or abnormal operation of this equipment or electrical shock. This equipment meets the technical
standard of the Ministry of Internal affairs and Communications (MIC).
Do not take apart, and do not remodel the equipment. It may cause a fire, the electric shock, and
the breakdown.
Ask our agency or office to dispose JUE-87 (EME). Illegal disposal may heat-up, firing, which is
affected by the impact or submerged of water.
To Next Page
Loading...
