JRC jue-87 - Page 135

3-75
3
Note:
(1) “Time” area (example: 14:20-14:25) shows the starting time and stopping time of the call.
(2) “Type of call” shows the communication type and the direction as follows:
• Type of call
S&F: Store & Forward communication (Telex communication)
S&F Poll: Automatic response communication with S&F to the polling command
S&F sched: Scheduled communication with S&F
S&F Dist: Distress priority communication with S&F
Data RPT: Data reporting
EDR: Enhanced Data Reporting
EDR Sched: Scheduled communication with EDR
EDR Prg: Programmed Position Report with EDR
EDR Poll: Immediate Position Report with EDR
EPADR: Enhanced Pre-assigned Data Reporting
SLCA: Slot Logical Channel Assignment (for EPADR)
SLCA Req: SLCA Request
SLCA Ctrl: SLCA Control (which is suspending SLCA or resuming SLCA)
EDR R-PADR: Re-sending data reporting by EDR which EPADR communication is failed
Distress: Distress alerting
Log-in: Log-in request
Log-out: Log-out request
PV test: Performance verification test
• Direction of call
R: Reception (Land subscriber to MES)
T: Transmission (MES to land subscriber)
(3) “Msg no” shows the serial number of the calls via each LES.
(4) “Size” shows number of characters in the message.
(5) 2nd line shows the result of the call.
Example)
Delivered to LES: Message is transmitted to LES.
Delivered to subscriber : Message is transmitted to (land) subscriber.
Reception success: Message from LES is received.
Call failure: Message transmission to LES or subscriber is
failed.
NOTE
“Delivered to LES” means the message you sent to land subscriber is received by LES as a relay point.
When you want to confirm whether the message is received by land subscriber, execution of “Delivery
confirmation request” is recommended.
When you turn ‘ON’ “delivery confirmation” function (see Fig. 3.8.1.) at the Telex window, you can
receive delivery confirmation automatically.
When you use “Multi-address function”(sending a message to up to 5 subscribers whom destination code
is same, via Telex
), result of transmission is displayed individually. (checking “Delivery confirmation
request” window is not necessary).