JRC jue-87 - Page 165

3-105
3
Step Operation IME/DTE Response
1
• Hold down
Alt key and press A
key on Main Menu.
• “Diagnostics” window is displayed.
2
• Move the cursor to “distress button
Test” and press
Enter key.
• “Distress Button test mode” window is
displayed.
3
• When the distress button is tested,
press the distress button till the buzzer
sounds for about 5 seconds or more.
• When the distress button test is
terminated, press
F7 (“Cancel”) key.
• The buzzer in DTE and IME is sounding 0.5
sec on, 1.0 sec off. Then, “SOS” is displayed
at the first line of DTE
• The buzzer sounding for about 30 seconds.
4
• (It passes 5 sec after pressing the
distress button.)
• The buzzer in DTE and IME is sounding 0.5
sec ON, 0.5 sec OFF.
• The “Distress” lamp on IME is blinking 0.5
sec ON, 0.5 sec OFF.
• “Distress Button Test” window is displayed.
Data source contents
Alarm history
software Version
distress button Test
F10: Previous
Dia
g
nostics
Distress buttons are under test now.
Press the distress button to test it.
If real distress alert to be sent,
Cancel the test mode.
F10: Cancel
Distress button test mode
--- Distress Button Test ---
Now distress button testing ---
F10: Cancel