3-115
3
Step Operation IME/DTE response
7
• Press F1 key.
• The following warning message is displayed.
8
• Move the cursor to "OK" and
press Enter key.
Note 1) If you want to request changing parameter of previously downloaded assignment, please
display EPADR Assignment window of the assignment.
If you want to request new assignment, please display EPADR Assignment window whose
status is “No Data”. However, when previously downloaded assignments satisfy following
requirements, new assignment can not be requested.
• Number of previously downloaded assignment is four.
• The transmission interval of previously downloaded assignment is “15 minutes”.
Note 2) The parameters, which can be set, are as follows:
(a) Status of the assignment is “No Data”.
• destination Address type
• lEs (which can be set when destination Address type is “SLCN”)
• Dnid/mem (which can be set when destination Address type is “SLCN & DNID”)
• transmission Interval
• number of Packets
• number of Reports
(b) Status of the assignment is “Active” or “Suspend”.
• transmission Interval
• number of Packets
• number of Reports
Note 3) When number of already downloaded assignment is one or more, new assignment, whose
transmission interval is “15 minutes”, can not be requested.
EPADR Assignment #1 Request OK?
OK Cancel
F10 Previous
Warnin
To Next Page
Loading...
