JRC jue-87 - Page 185

4-7
4
0x000000
No alarm (If there are any alarm,
Add the following each status value)
+ 0x800000
EME ROM data alarm
+ 0x400000
EME RAM data alarm
<Note>
If user stops power supply without
“Log-out”, this bit becomes “high”.
+ 0x200000
EEPROM data alarm
+ 0x100000
EEPROM FATAL alarm
+ 0x080000
External UART data alarm
+ 0x040000
EME-IME connection alarm
+ 0x020000
EME Internal GPS alarm
+ 0x010000
External GPS alarm
+ 0x008000
TX DURATION alarm
+ 0x004000
EME PLL1 UNLOCK alarm
<Note>
If this bit becomes “high”, transceiver
board of EME might have some
troubles of PLL ICs.
+ 0x002000
EME PLL2 UNLOCK alarm
<Note>
If this bit becomes “high”, transceiver
board of EME might have some
troubles of PLL ICs.
+ 0x001000
EME MODEM Software alarm
+ 0x000800
EME MODEM Hardware alarm
+ 0x000400
DISTRESS button1 alarm
+ 0x000200
DISTRESS button2 alarm
+ 0x000100
DISTRESS button3 alarm
+ 0x000080
Reserved
+ 0x000040
SECURITY ALERT button1 alarm
+ 0x000020
SECURITY ALERT button2 alarm
+ 0x000010
SECURITY ALERT button3 alarm
Alarm(XXXXXX)
+ 0x000008
SECURITY ALERT button4 alarm
0x0000
Default menu
(Add the following each status value)
+ 0x8000
READY
+ 0x4000
SYNC
+ 0x2000
CARRIER
+ 0x1000
LOG IN
+ 0x0800
EGC Mode
+ 0x0400
Reserved
+ 0x0200
Reserved
+ 0x0100
Preheat
+ 0x0080
DISTRESS button1detection
+ 0x0040
DISTRESS button2 detection
+ 0x0020
DISTRESS button3 detection
+ 0x0010
Reserved
+ 0x0008
SECURITY ALERT button1 detection
+ 0x0004
SECURITY ALERT button2 detection
+ 0x0002
SECURITY ALERT button3 detection
⑮
ST:XXXXXX/YYYY
(ST:000000/D080)
Status(YYYY)
+ 0x0001
SECURITY ALERT buttoh4 detection