3-22
In “edit telex file” mode;
Note 1) The characters which can use on the land telex line can be input. So, the following characters
and the small letters are rejected in the file:
!, @, #, $, %, ^, &, *, _, {, [, ], }, :, ¥, ;, ”, ~, ’, and -
Note 2) Edit telex file uses the extension “.TLX” as file name.
Blank space and the characters specified in Note 1 cannot be used for file name. It may cause
an error at the schedule transmission.
To erase file name, use Delete key, or Backspace key.
To erase all characters, use Delete key. To erase characters one by one, use Backspace key.
Note 3) After editing USB drive file, saving and read-out place of file is changed to USB drive
( E : ).
When you want to save and read-out files in the memory of the IME/DTE, enter F :
into the column of “File:”.
Note 4) Pull out USB drive after return the read-out place to inner IME/DTE memory ( F : ), when
you completed editing of USB drive.
Error is occurred when you log-in to the editing mode again, if you pull out the USB drive
without change the read-out place to F : from E : .
To Next Page
Loading...
