JUKI DLN-6390 - CAUTION BEFORE OPERATION; Pre-Operation Checks

vi
CAUTION BEFORE OPERATION
• Be sure to ll the oil hole with oil before use.
• Clean the sewing machine thoroughly before using it for the rst time.
• Remove all dust collected on the sewing machine during the transportation.
• Conrm that the voltage and phase are correct.
• Conrm that the power plug is properly connected.
• Never use the sewing machine in the state where the voltage type is different from the
designated one.
• The direction of rotation of the sewing machine is counterclockwise as observed from the
handwheel side. Be careful not to rotate it in reverse direction.
• When operating the sewing machine, turn ON the power switch after properly setting the head
on the table.
• For the rst month after set-up, use the machine at a reduced sewing speed of 4,000 sti/min or less.
• Operate the handwheel after the sewing machine has totally stopped.
• Do not tilt the machine head toward this side since oil leakage or parts breakage occurs.
• Before starting a test run, remove the bobbin case and the needle thread from the machine.
WARNING :
To avoid malfunction and damage of the machine, conrm the following.