Remove a Member Switch and Make Its Member ID Available for Reassignment to a
Different Switch
When you remove a member switch from the Virtual Chassis configuration, the
master keeps its member ID on reserve. To make that member switch’s member ID
available for reassignment, use the request virtual-chassis recycle command.
NOTE: When you add or delete members in a Virtual Chassis configuration, internal
routing changes might cause temporary traffic loss for a few seconds.
Related Topics ■ Monitoring Virtual Chassis Configuration Status and Statistics
■ Adding a New Switch to an Existing Virtual Chassis Configuration (CLI
Procedure) on page 75
116 ■ Remove a Member Switch and Make Its Member ID Available for Reassignment to a Different Switch
Complete Hardware Guide for EX 3200 and EX 4200 Switches
To Next Page
Loading...
