Table 29: AC Power Cord Specifications (continued)
Plug StandardsElectrical SpecificationsCountry/Region
CEI 23–16/VII250 VAC, 10 A, 50 HzItaly
JIS 8303125 VAC, 12 A, 50 Hz or 60 HzJapan
NEMA 5-15125 VAC, 10 A, 60 HzNorth America
BS 1363A250 VAC, 10 A, 50 HzUnited Kingdom
Figure 27 on page 57 illustrates the plug on the power cord for each country or region
listed in Table 29 on page 56.
Figure 27: AC Plug Types
CAUTION: The AC power cord for the EX-series switch is intended for use with the
switch only and not for any other use.
Related Topics ■ General Safety Guidelines and Warnings on page 130
■ General Electrical Safety Guidelines on page 153
■ Preventing Electrostatic Discharge Damage on page 138
■ Power Supply in EX 3200 and EX 4200 Switches on page 27
Network Cable Specifications
■ Network Cable Specifications on page 57
Network Cable Specifications
EX-series switches support interfaces that use various types of network cables.
For instructions on connecting an EX-series switch to a network for out-of-band
management using an Ethernet cable with an RJ-45 connector, see “Connecting an
EX-series Switch to a Network for Out-of-Band Management” on page 85.
For instructions on connecting an EX-series switch to a management console using
an Ethernet cable with an RJ-45 connector, see “Connecting an EX-series Switch to
a Management Console” on page 86.
Network Cable Specifications ■ 57
Chapter 2: Preparing the Site for Switch Installation
To Next Page
Loading...
Need help?
General
