Juniper EX Series

■ Laser and LED Safety Guidelines and Warnings on page 143
■ Installation Instructions Warning on page 146
■ Grounded Equipment Warning on page 163
Laser and LED Safety Guidelines and Warnings
EX-series switches are equipped with laser transmitters, which are considered a
Class 1 Laser Product by the U.S. Food and Drug Administration and are evaluated
as a Class 1 Laser Product per EN 60825–1 requirements.
Observe the following guidelines and warnings:
■ General Laser Safety Guidelines on page 143
■ Class 1 Laser Product Warning on page 143
■ Class 1 LED Product Warning on page 144
■ Laser Beam Warning on page 144
General Laser Safety Guidelines
When working around PIMs, observe the following safety guidelines to prevent eye
injury:
■ Do not look into unterminated ports or at fibers that connect to unknown sources.
■ Do not examine unterminated optical ports with optical instruments.
■ Avoid direct exposure to the beam.
WARNING: Unterminated optical connectors can emit invisible laser radiation. The
lens in the human eye focuses all the laser power on the retina, so focusing the eye
directly on a laser source—even a low-power laser—could permanently damage the
eye.
Class 1 Laser Product Warning
WARNING: Class 1 laser product.
Waarschuwing Klasse-1 laser produkt.
Varoitus Luokan 1 lasertuote.
Attention Produit laser de classe I.
Warnung Laserprodukt der Klasse 1.
Laser and LED Safety Guidelines and Warnings ■ 143
Chapter 7: Safety and Regulatory Compliance Information