Juniper EX Series Complete Hardware Guide

Power Disconnection Warning
WARNING: Before working on the switch or near power supplies, unplug the power
cord from an AC switch.
Waarschuwing Voordat u aan een frame of in de nabijheid van voedingen werkt,
dient u bij wisselstroom toestellen de stekker van het netsnoer uit het stopcontact
te halen.
Varoitus Kytke irti vaihtovirtalaitteiden virtajohto, ennen kuin teet mitään
asennuspohjalle tai työskentelet virtalähteiden läheisyydessä.
Attention Avant de travailler sur un châssis ou à proximité d'une alimentation
électrique, débrancher le cordon d'alimentation des unités en courant alternatif.
Warnung Bevor Sie an einem Chassis oder in der Nähe von Netzgeräten arbeiten,
ziehen Sie bei Wechselstromeinheiten das Netzkabel ab bzw.
Avvertenza Prima di lavorare su un telaio o intorno ad alimentatori, scollegare il
cavo di alimentazione sulle unità CA.
Advarsel Før det utføres arbeid på kabinettet eller det arbeides i nærheten av
strømforsyningsenheter, skal strømledningen trekkes ut på vekselstrømsenheter.
Aviso Antes de trabalhar num chassis, ou antes de trabalhar perto de unidades de
fornecimento de energia, desligue o cabo de alimentação nas unidades de corrente
alternada.
¡Atención! Antes de manipular el chasis de un equipo o trabajar cerca de una fuente
de alimentación, desenchufar el cable de alimentación en los equipos de corriente
alterna (CA).
Varning! Innan du arbetar med ett chassi eller nära strömförsörjningsenheter skall
du för växelströmsenheter dra ur nätsladden.
Related Topics General Safety Guidelines and Warnings on page 130■
■ General Electrical Safety Guidelines on page 153
■ AC Power Electrical Safety Guidelines on page 154
Multiple Power Supplies Disconnection Warning
WARNING: EX 4200 series switches have more than one power supply connection.
All connections must be removed completely to remove power from the unit
completely.
Related Topics General Safety Guidelines and Warnings on page 130■
■ General Electrical Safety Guidelines on page 153
156 ■ Power Disconnection Warning
Complete Hardware Guide for EX 3200 and EX 4200 Switches

Juniper EX Series Specifications

General

Series	EX Series
Category	Switch
Layer	Layer 2/3
Operating System	Junos OS
Managed	Yes
ACLs	Yes
Port Density	Varies by model
Power over Ethernet (PoE)	Available on some models
Virtual Chassis	Supported on some models
Form Factor	Fixed configuration, Modular
Switching Capacity	Varies by model
Forwarding Rate	Varies by model
Power Supply	Varies by model (AC or DC, redundant options available)
Management	CLI, Web UI, SNMP
Redundancy	Power supply, fan, Virtual Chassis
Latency	Varies by model
Jumbo Frames	Supported
VLAN Support	Yes
MAC Address Table Size	Varies by model
QoS	Yes
Energy Efficiency	EEE (802.3az)
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	0° to 45° C
Storage Temperature	-40° to 70° C
Humidity	5% to 90% non-condensing
MTBF	Varies by model
Warranty	Limited Lifetime