Mounting an EX 3200 or EX 4200 Switch on a Wall ...............................69
Virtual Chassis Cabling Configuration Examples .....................................72
Adding a New Switch to an Existing Virtual Chassis Configuration (CLI
Procedure) ........................................................................................75
Adding a New Switch to an Existing Virtual Chassis Configuration
Within the Same Wiring Closet ..................................................75
Adding a New Switch from a Different Wiring Closet to an Existing
Virtual Chassis Configuration .....................................................76
Connecting Earth Ground to an EX-series Switch ....................................78
Connecting AC Power to an EX 3200 or EX 4200 Switch ........................79
Connecting DC Power to an EX 3200 or EX 4200 Switch ........................81
Connecting an EX-series Switch to a Network for Out-of-Band
Management ....................................................................................85
Connecting an EX-series Switch to a Management Console ....................86
Connecting a Virtual Chassis Cable to an EX 4200 Switch .......................88
Chapter 4 Connecting the Switch and Performing Initial Configuration 91
Connecting and Configuring an EX-series Switch ..........................................91
Connecting and Configuring the EX-series Switch (CLI Procedure) ..........91
Connecting and Configuring the EX-series Switch (J-Web Procedure) ......92
Part 3 Hardware Maintenance, Replacement, and Troubleshooting
Chapter 5 Replacing Hardware Components 99
Field-Replaceable Units in EX-series Switches ...............................................99
Installing and Removing EX-series Switch Hardware Components ..............100
Installing an Uplink Module in an EX-series Switch .....................................101
Removing an Uplink Module from an EX-series Switch ...............................102
Installing an SFP or XFP Transceiver in an EX-series Switch ........................104
Removing an SFP or XFP Transceiver from an EX-series Switch .................106
Installing a Power Supply in an EX-series Switch .........................................107
Removing a Power Supply from an EX-series Switch ..................................108
Installing a Fan Tray in an EX-series Switch ................................................110
Removing a Fan Tray from an EX-series Switch ..........................................112
Disconnecting a Virtual Chassis Cable from an EX-series Switch .................113
Replacing a Member Switch of a Virtual Chassis Configuration (CLI
Procedure) ............................................................................................114
Remove, Repair, and Reinstall the Same Switch ...................................115
Remove a Member Switch, Replace with a Different Switch, and Reapply
the Old Configuration .....................................................................115
Remove a Member Switch and Make Its Member ID Available for
Reassignment to a Different Switch ................................................116
Table of Contents ■ ix
Table of Contents
To Next Page
Loading...
